Changing engine mounts!

Started by ro284, July 24, 2007, 10:19:37 PM

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

ro284

As above, iv\'e got some replacement mounts, Is there a \'how to\' somewhere? any one done this please? whats involved? how long ? how difficult?
Cheers Bob

m4drx

you need something to lift your engine out or support it. garage tools required basically not just on your back job basically.

subframe must come down or engine out.
fduk.

RobbieRX-7

#2
The engine sits on the subframe, so lowering the subframe is not an option. You can lift the engine with a jack or hoist and remove the mounts without actually taking the engine out. It\'s gonna be a bit tight and you should also have the front of the car high up on ramps or axle stands so you can get underneath and remove the mounts. Im not sure if you have to remove the downpipe to cat bolts, probably best to tbh

ro284

Thanks guys, this could be a good time to fit a DP at the same time then?
Bob

bobster

Mines Black and dirtier than Donatos. But hey, no-one asked for a good clean fight.

Initial-D

Lol a fun job! You don\'t need to remove the DP, just hoist the engine up enough to unbolt the mounts as above. If you have the tools it can be done in an hour.
Cheers


Ben

Time Attack UK â€" FD build updates http://bean-bandit.blogspot.com/
RHD car profile - Please vote for me! http://www.rhdjapan.com/rhdjapanridez/2200/Matsuda-FD3-RX-7-GTフェンダー


Laeeq

Done mine yesterday and took me 1 hour and most of the time was jacking the car up...then just take 2 14mm bolts off from each mount and jack the engine from gearbox.  It was easier then i thought, just make sure the car is on stands and use a flat piece of wood under the gear box and lift.  No need to take the down pipe off just take the strut bar and intercooler pipes off....easy:cheers
Laeeq

m4drx

Quote from: LaeeqDone mine yesterday and took me 1 hour and most of the time was jacking the car up...then just take 2 14mm bolts off from each mount and jack the engine from gearbox.  It was easier then i thought, just make sure the car is on stands and use a flat piece of wood under the gear box and lift.  No need to take the down pipe off just take the strut bar and intercooler pipes off....easy:cheers


£30 an hour ok? ill pop down this week :)
fduk.

Laeeq

Quote from: m4drx£30 an hour ok? ill pop down this week :)

I will do it free for you...:wiggle thats if you can drive all the way down to east london...lol
Laeeq

ro284

I charge twice your rate m4, therefore i will save twice as much doing it myself! thanks for replies guys i feel confident i can manage this, have a pit i can use too, luxury even!
Bob