microtech mtx ecu on fd

[stuart wizy]

how is everyone? ive not logged on here for some time due to being well busy at work.
here goes-
ive rebuilt my fd and run it in on std ecu,
I have a microtech ecu with hand controler, software and download cable for my fc drag car which isnt finished yet so thought what the hell, use it on my fd and learn a bit of diy mapping for when i finish my drag car.
I have a spare standard ecu which im going to scrap to get the block plug, I plan to solder up a loom to this plug via the microtech hence being able to reuse std ecu back in the fd without cutting and snipping wires.
I have the microtech wiring diagram, all I need is a diagram of what each pin is on the standard engine loom ecu plugs to wire it up using all the original ecu loom plugs.
I dont plan on tuning the seeds out of my fd by the way, just a bit more boost and water Injection basicly just to learn how to use the software.
does anyone have a link anywhere with this information??
many thanks
stu

[MikeLMR]

is the microtech setup correctly for an FD ignition system ? I was of the understanding that they were quite inflexible in that regard and had to be setup from the factory for a specific ignition setup

[stuart wizy]

on the manual it says it can be used for fd and fc slight difference in wiring. there are 2 wiring diagrams 1 for fd 1 for fc in the wiring manual.
I found a link with all pin wires labeled up on the std ecu plugs but seem to have lost it!
cheers
stu

[McCARTHY]

When you get the mircotech you need:

The loom harness
coils
ECU or course
and the X4 ignition module

And they are friggin awsome :chat

[stuart wizy]

ive got it all mate, bosch coils comander magnecors, I bought it last year for my drag car and its sat on a shelf gathering dust so I thought why not use and learn it on the fd until I finish my fc.

[stuart wizy]

this is what im after but with all the pin conections, there is only a few pins labeled on this diagram     http://www.innovatemotorsports.com/resources/1993_1995_Mazda_RX-7.php
anyone seen one or have a link???
cheers stu

[McCARTHY]

Do you not have the Mircotech FD harness?

Do forgive me if i\'m being a muppet buddy, what is it your tring to do or need?

[kev-yorks]

The microtech isn\'t plug and play you normally replace the full engine wiring loom.
 
Drop Microtech a email i\'m sure they will have a pinout diagram
Kevin

[sadgoth]

You may need to return it to microtech as the base map for the FD is different from the FC

[Timrxmotors]

The Microtech can be \'plug and play\',you just need the adaptor to plug into the standard loom.I have done a couple of FD\'s this way,no chopping of wires,just plug in.
You will find the ignition timing and dwell are set different between the FD and the FC.