My recent efforts

[allstaruk]

Here are some pics I\'ve taken of the work i\'m doing, sometime you wish you hadn\'t bloody started don\'t you.


Sometimes I wish I hadn\'t started.


Do you think i\'m going over the top



And finally any one spot the difference?


Al

[markrx7]

oooooooooooooooooh shiny stuff ive been doin the same with bits to

[allstaruk]

Its going to get a lot worse before it gets better too.

A

[arrouk]

that uim wants porting out to fit the gaskit.lol

matt

[allstaruk]

I think you might be right

A

[matto]

looks good what intercooler set up is that?

[allstaruk]

Its a greddy 2row I think its the M spec one I am in the process of fitting it as part of all the jobs I\'m doing.

A

[bobert]

I like the modified uim. I might have a go at that this week.
What’s it like to do? Any tips?

[allstaruk]

Its pretty easy I did have a couple of problems though.

Easierst way is to remove the butterflies that are screwed on and then pull out rod unfortunately they just rounded off for me so I cut them out.

THen I sawed throught the centre to open it up as much as possible, then put the gastket on and used that as a template to draw round so I knew what size a wanted, I found a small worn out angel grinder disk popped that in and just worked back to my guide lines, then got a die grunder bit in the drill and tidyed it all up.

Alan

[bobert]

chears, I will have a go at that.

hows the priamry rail getting along?

[Fish]

I have a complete set of front and rear (upper/lower) arms that I might do something with.

Fish

[allstaruk]

Primary rails comming along fine its at the engineergin place down the rd being milled down to take the 850\'s the next problem is how do i connect the seconday fule rail to my FRP. Seeing as I have an aftermartet FPR then I need to remove the one from the primary rail but if i do that how do I attach the hose, I have seen on amerinan websites a replacemnt that screws on and allows you ro fot -jic unions but I don\'t know any where in the uK

A

[bobert]

Is this any good to you
http://photobucket.com" target="_blank">http://i103.photobucket.com/albums/m141/bobert_wal/rx7/post-10-1061781026.jpg" border="0" alt="Photobucket - Video and Image Hosting">

[allstaruk]

Not it the slightist mate, I have that picture its from rx7club from the thread about fitting keiths fuel rails, thats an aftermarket seconadary rail which comes tapped, I am trying to use the stock rail which isn\'t tapped and find a way of converting it to take -6 unions.

I would however like to tap my primary rail like that but I the rail I have doesn\'t have enough metal on it to do it like the ones in the pictures.

Alan

[bobert]

what size secondary injectors are you going to use?