Suggestions to cure this problem please!

[m4drx]

is there any way of checking this? i think this could be the solution to all my woes!!!!!!!!!!!!!!!

i have checked every single hose on the entire stock turbo system (finding lots and lots of problems) currently mine is doing the above.

i have tried to read the fault codes joining the the FEM and TEN terminal (this should be right for uk cars right) but it just keeps flashing short flashes over and over i stopped counting after 50. does this mean there are no faults or does this fault not show?

any help would be great!

[robedwards99]

is there any way of checking this? i think this could be the solution to all my woes!!!!!!!!!!!!!!!

i have checked every single hose on the entire stock turbo system (finding lots and lots of problems) currently mine is doing the above.

i have tried to read the fault codes joining the the FEM and TEN terminal (this should be right for uk cars right) but it just keeps flashing short flashes over and over i stopped counting after 50. does this mean there are no faults or does this fault not show?

any help would be great!

For the sake ot £27 from Mazda and 20 mins to fit I think its worth a shot.. either that or go to a specialist and get them to run a diagnostic (that cost me about £70)

[m4drx]

20 mins? do i need to take the plenum off?

i had it off today! damn if only i\'d known.

i am almost certain i will do this or use a triumph one!

do you know the part number at all? mazda round here do not seem to be able to identify any part on my car!

i am experiencing this behavior most of the time also - when this fails is it only intermittent?

[m4drx]

i know where it is now but i cant decide whether to relocate to the elbow or not

[Grizzly]

is there any way of checking this? i think this could be the solution to all my woes!!!!!!!!!!!!!!!

i have checked every single hose on the entire stock turbo system (finding lots and lots of problems) currently mine is doing the above.

i have tried to read the fault codes joining the the FEM and TEN terminal (this should be right for uk cars right) but it just keeps flashing short flashes over and over i stopped counting after 50. does this mean there are no faults or does this fault not show?

any help would be great!

It repaets the same fault code over and over.

Down load this and look up the fault codes (there is quite a few) it will give you an idea of what your after.http://www.wrex-racing.com/html/fd/...shop_manual.zip

[robedwards99]

20 mins? do i need to take the plenum off?

i had it off today! damn if only i\'d known.

i am almost certain i will do this or use a triumph one!

do you know the part number at all? mazda round here do not seem to be able to identify any part on my car!

i am experiencing this behavior most of the time also - when this fails is it only intermittent?

Yes it\'s was only intermittant on mine.

Sensor, Air Temp - N3A118845 - £27.01

[m4drx]

thanks guys i appreciate your help.

my problem i think gets worse the hotter the car gets and happens all the time but i think i will give this a try tomorrow.

i have checked  the entire turbo system piping. comp readings are 7.6 all round and 7.8 all round leads look in very good condition and are magnecor 8mm and coils look newish.

im not sure about the leads as they look fine but fittment isnt the best i am thinking that if they were faulty they would never be able to sustain full boost etc but i am not sure how to test them?

do you guys know how to test them? reisistance i think?

thanks again

[m4drx]

would this show up as a fault?