Clutch... How to???

[Grizzly]

The problem i had was with the Clutch arm in place it was quite heaverly sprung back so i could only lever one side of the Snap ring holder. Basicly the more force i tried to push it in the more it went out of shape until it just kept poping out when i pushed the clutch.

So now i like to know its in (so the box does\'nt need to come off again when i bend the Snap ring holder )

[Jono FD3]

Didn\'t realise but there was an istruction booklet in with the clutch kit!!!

It tells you to unbolt the box, wlide it back 30 - 40mm then go through the resulting gap to releas the bairing as shown in the vid...... then putting it back together you fit that part back to the gearbox & clutch arm, offer the box up & push the unit back into the clutch using the clutch arm!!!

Looks so simple, but I bet it aint!!!!

Jono