water injection

Started by davyv, June 26, 2006, 04:08:37 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1 2
User actions

davyv

June 26, 2006, 04:08:37 PM
how does water injection work and is it hard to fit.Thanks.

rx7veilside

#1
June 26, 2006, 04:24:10 PM
just injects fine spray at set boost level which will cool intake temp..fairly easy to fit for someone handy..//www.coolingmist.com from the states do a very good kit and give detailed fitting inst

davyv

#2
June 26, 2006, 04:27:44 PM
Just about to put a new rad and fm intercooler in , so is winjection worth doing.

Mr J.T

#3
June 26, 2006, 07:13:16 PM
ive just finished putin mine in today took me about 5-6hours in total. just using it as a cooler atm. and DAMN does it work. the temp just dives down im driving hard in the 20\'s in heat

vxer

#4
June 26, 2006, 07:59:18 PM
Quote from: Mr J.Tive just finished putin mine in today took me about 5-6hours in total. just using it as a cooler atm. and DAMN does it work. the temp just dives down im driving hard in the 20\'s in heat

What was the most difficult bit of the install?

Cheers, Paul.

Fish

#5
June 26, 2006, 08:01:11 PM Last Edit: June 26, 2006, 08:03:14 PM by Fish
Dont forget about ERL. British company that we should all be supporting. IMO.

Might be worth reading the water injection thread in the techie section.

Fish

Mr J.T

#6
June 26, 2006, 08:01:37 PM
it was pretty damn easy hardest part with so much in a rex is gettin wires through bulk head that shows how easy it is. if you want any help or advice jsut ask

vxer

#7
June 26, 2006, 08:14:11 PM
Quote from: Mr J.Tit was pretty damn easy hardest part with so much in a rex is gettin wires through bulk head that shows how easy it is. if you want any help or advice jsut ask

Do you have to remove the dash?

Cheers, Paul.

Mr J.T

#8
June 26, 2006, 08:17:28 PM
hell no, these a couple grommets in the bulk just have to be patient and work then through

vxer

#9
June 26, 2006, 08:18:31 PM
Quote from: Mr J.Thell no, these a couple grommets in the bulk just have to be patient and work then through

Do you need to wire in an ignition live power source - where did you pull it from?

Cheers, Paul.

davyv

#10
June 26, 2006, 09:13:18 PM
Where have you put your pump and does it make much noise

Mr J.T

#11
June 26, 2006, 09:14:29 PM
Pumps In The Engine Bay It Makes A Noise But With Engine On Etc U Cant Here It

davyv

#12
June 26, 2006, 09:15:47 PM
Where have you taken the water from

Mr J.T

#13
June 26, 2006, 09:35:31 PM
an ali tank in the boot

vxer

#14
June 26, 2006, 09:46:09 PM
Quote from: Mr J.Tan ali tank in the boot

Did you notice less knock on boost (i assume you have a PFC) after you fitted this?

Ta, Paul.
Print
Go Up Pages1 2
User actions