End float question

[dandan]

Hi all,
This question is directed at all you engine builders out there:
I checked the movement on the end float on my engine the other day and tonight I finally got round to checking what the tolerances are supposed to be by watching the DIY-RE dvd again.
The dvd says movement should be between .03 and .07mm but when I checked mine it is .1mm, the engine has run a few thousand miles since the last rebuild so is this acceptable?
.03 over sounds like very little, and engine was running fine before but I don\'t want to take too many undue risks if I can help it, then again I don\'t really want to have to strip the engine down just to adjust .03mm.

What do people think?

[oldone]

As long as you got some minute movement,it is cool.........to much and the motor is sloppy,which you dont want.Dont fret yourself over the last bit........................ :cool