Apexi power FC

Started by Fats, April 06, 2006, 03:08:38 PM

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

Print
Go Down Pages1
User actions

Fats

April 06, 2006, 03:08:38 PM Last Edit: April 06, 2006, 03:11:28 PM by Fats
When i fit my power FC to my 95 FD, will i be able to run it on its base map with the air pump disconnected and the cat removed until i can get it mapped. i am going to take it to WGT to have the mapping done, there the closest to where i live and heard they are pretty good!

Fats

#1
April 07, 2006, 03:01:14 PM
any ideas?

BlitzBoy

#2
April 07, 2006, 03:13:32 PM
yes you can drive it , but dont boost it until mapped
"Piston Killa" 3rd Gen\'94 \'Oldone Racing Full Bridge Ported REW 13b engine with SCR seals\'. HKS T51 KAI turbo BBM mapped Motec ECU

JDS/HKS Street Class Championship Runner up 2011
Rotorstock winner 08,09
http://pistonkilla.blogspot.com/
old spec HB T51 470 @ wheels @ 1.2 BAR, 555 @ fly 10.46 @ 130 @ 1.25 Bar
new spec FB T51 482 @ wheels @ 1.15 BAR, 570 @ fly

New Project
"el fénix" RX2 by Mark & Mark

kbareham

#3
April 07, 2006, 04:55:04 PM
Agreed, drive it but be careful with boost. Mine has decat, PFC, no air pump, and ARC airbox. I have now got datalogging on pretty much everything you can log. The base map took the knock levels high on anything over atmospheric at around 3000RPM, so keep off boost there particularly. It is also very rich on the over-run from 1200 - 2400 RPM, and lean on light load just under 2K. The good news is that it runs fine in the closed loop area (i.e around 2k -3k RPM, lightly loaded) So I would say try to keep it in the closed loop area as much as possible - you will probably also notice better fuel consumption!

Get it mapped and enjoy!


Keith

Fats

#4
April 07, 2006, 05:14:07 PM
How about driving with the cat off, air pump connected and standard ecu on, will i be ok using it for a while?
Print
Go Up Pages1
User actions