EGI running gear and electrics in a turbo II

[samfc3s]

TURBONUTTAG...u from donny??i used to live in Cantley few yr ago........

and i do go back to donny to see my fren every so often......but i hardly see any T2

[FD3SNuttah]

haha yeh i live in Bessacarr!!!

[samfc3s]

good good....when next time goin to donny we should hv a T2 meet...hahaa

[FD3SNuttah]

when u get the car the conversion should be a LOT easier than mine.... as everything you dont need is going to be removed.

so far i have sussed out that i have to swap the following.

clocks.
engine loom.

logicon

diff - the convertable has a different ratio which will not do me lower end and the torque.

engine and box

make a custom mount for the gear box (a bit of metal with two holes!)
pedals.
clutch master cylinder.
and then wire the whole thing which isnt going to be too bad...

i am thinking of booking a week from work to do the main swap and tranfer and then spend weekends finishing bits off.. i have got most tools.such as various lengths of wrench, airtools and a compressor, an engine crane etc a few jacks and a few floor stands..  i have a guy from work helping me and the  FSM\'s and a load of "how to\'s"  cant go wrong can i LOLOL


you will most likely have to do the same....

and of course my lovely mates on the MRC!!!! whos up for helping me out on a weekend then? all the homemade curry (my mom made) you can eat!!!!

[FD3SNuttah]

of course sam your welcome anytime pal.