Apexi problems

Started by dturpin, July 15, 2005, 04:11:04 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

dturpin

I have just got my Apexi Power FC and commander for my FD, and have tried to put it in.  When I was doing the idle set up like it says in the instructions about leaving it for 10 min, then put the rear dimister on leave for 10 min, then the air con and leave for 10 min again.  While I was doing this the idle was irratic but seemed to settle down, but the car would just stall.  And I don\'t know if this is correct.
Can anyone offer me some help please.

matrx7

phone re worx they are the nuts with these things. You can get there number on the main page of this site

Mazdarotaryparts

You will hear the car\'s idle rise and fall several times during this inital operation on a stock car ?, but l have never known one to actualy cut out.

Did you have a very slow tick over before you put the PFC one as this would cause it.

If you have conserns put your stock ECU back in and check the cars running OK with this fitted, before exploreing anything else.
REgards
Clive

Mazdarotaryparts
Racingbeateurope
Racecarbattery
shyauto

We aim to help and assist our customers make the right choices for their Mazda Rotary or MX-5  whether they be standard or modified. If you need further assistance with your inquiry, please do not hesitate to contact us:-
sales@mazdarotaryparts.com T:- 44 (0) 1474 361 800
sales@racingbeateurope.com T:- 44 (0) 1474 777 800
sales@shyauto.com             T:- 44 (0) 1474 771 800

Fish

Quote from: matrx7phone re worx they are the nuts with these things. You can get there number on the main page of this site

You should contact the place of purchase! Not just anyone. Nothing against ReWorx, but they might not havent made money on your purchase, so why should they support it!

Fish

dturpin

I didn\'t have a very low idle before, it was never a very stable idle would wonder up and down  a bit by a few 100 revs.