Rotus Project Build

Eccentric shaft · July 01, 2022, 05:52:13 PM

The range, the range! The Oh! Range!

Jamie R · July 01, 2022, 06:21:23 PM

Quote from: Eccentric shaft on July 01, 2022, 05:52:13 PM
The range, the range! The Oh! Range!

Someone asked me if the paint on the body was straight out the gun or had been polished coz it was a bit orange peel.......

........... well it is authentic, it is orange

Casey · July 01, 2022, 08:09:51 PM

Reaching for sunglasses.............

boosted · July 01, 2022, 08:21:46 PM

Its not Jamies.. its Terrys..

Sent from my SM-G977B using Tapatalk

Casey · July 01, 2022, 08:37:41 PM

Quote from: boosted on July 01, 2022, 08:21:46 PM
Its not Jamies.. its Terrys..

Sent from my SM-G977B using Tapatalk

took me a couple of seconds to get that!

Jamie R · July 01, 2022, 09:04:23 PM

A friend of mine said it looks like a huge baked bean

I said a baked bean has more hp !!

I'll just leave this here

Sent from my iPhone using Tapatalk

Jamie R · July 01, 2022, 09:11:10 PM

Had to colour code it ....

Chrysler hemi looks like peach

Chevy orange looks too red

Sent from my iPhone using Tapatalk

clive · July 02, 2022, 09:27:41 AM

Getting there

Best looking RX-8 Rotor housings surfaces I have seen for ages

Jamie R · July 02, 2022, 11:15:25 AM

Thanks

Shame you won't see a lot of it

Sent from my iPhone using Tapatalk

Jamie R · July 02, 2022, 11:52:41 AM

When you're trying to measure 400 ugga duggas with a piece of 80 x 40 box and a socket welded on the end

Sent from my iPhone using Tapatalk

Richnzj · July 02, 2022, 08:32:14 PM

brilliant

Sent from my SM-G973F using Tapatalk

MattScott · July 02, 2022, 10:42:09 PM

Quote from: Jamie R on July 02, 2022, 11:15:25 AM

Thanks

Shame you won't see a lot of it

Sent from my iPhone using Tapatalk

But what you can see will be SHOUTING at you !

Sent from my SM-G973F using Tapatalk

Jamie R · July 03, 2022, 06:08:22 PM

Would sir care for fries with his front pulley e shaft bolt??

Remember zinc plating (only on high tensile bolts) causes hydrogen embrittlement. So you hear to heat treat them prior to passivating and fitting.

With the high torque figures Mazda specify I dun want that bad boy snapping off in the end of the e shaft

Sent from my iPhone using Tapatalk

Casey · July 03, 2022, 09:45:56 PM

Can I have some 2T oil on my fries please

Interesting, I'll have to read up about heat treating after plating

Jamie R · July 04, 2022, 05:44:21 AM

Quote from: Casey on July 03, 2022, 09:45:56 PM
Can I have some 2T oil on my fries please

Interesting, I'll have to read up about heat treating after plating

I got the info from out the instructions with the plating kit.

WoooAhhh stop press!!!

A man ? Who reads instructions??? Well never claimed to be normal lol

Sent from my iPhone using Tapatalk