MX-5 NC with RX-8 231 Engine

Paul_13 · February 10, 2019, 04:50:56 PM

Black - vdi
Blue - sap
White - ssv

Sent from my SM-G965F using Tapatalk

Paul_13 · February 10, 2019, 04:51:21 PM

Traced wire colours

Sent from my SM-G965F using Tapatalk

boosted · February 10, 2019, 04:51:47 PM

Remember now.. the vac black pipe is colour coded...white SSV blue airpump black vdi

Sent from my SM-N950F using Tapatalk

boosted · February 10, 2019, 04:52:50 PM

We concour..!!

Sent from my SM-N950F using Tapatalk

boosted · February 10, 2019, 04:56:55 PM

Lol 2nd time in 6 months the dusty bonnet has been taken off...when i take it for a blast gonna scare the life outta me...

Sent from my SM-N950F using Tapatalk

boosted · February 10, 2019, 05:00:26 PM

Both vdi and ssv have sensors to check there working and would generate a code if not...unless old pcm like mine was for ssv...but its not a hesitate its a hard cut if not working. The apv ( motor) cycles on ignition start up check

Sent from my SM-N950F using Tapatalk

Paul_13 · February 10, 2019, 05:05:04 PM

I've only got a sensor on the ssv. None on the vdi

Sent from my SM-G965F using Tapatalk

boosted · February 10, 2019, 05:08:35 PM

Im sure mine has....know im not so sure...but im not going out to garage again ha ha...

Sent from my SM-N950F using Tapatalk

Paul_13 · February 10, 2019, 05:09:26 PM

I've got one in the pic. None on the vdi.

Thanks much appreciated

Sent from my SM-G965F using Tapatalk

Paul_13 · February 10, 2019, 05:12:01 PM

Shows a sensor on ssv can't see one for vdi

Sent from my SM-G965F using Tapatalk

boosted · February 10, 2019, 05:16:25 PM

I looked at a vdi on ebay...nope no sensor onit to confirm operation...well today a school day for me i thought there was...well there should be 1...

Sent from my SM-N950F using Tapatalk

Paul_13 · February 10, 2019, 05:17:49 PM

Which would explain if it doesn't operate properly you don't get any codes

Sent from my SM-G965F using Tapatalk

boosted · February 10, 2019, 05:30:36 PM

Yep, which is what i had when my SSV was not happening due to early pcm not having the fault code....does it Move freely should be able to operate it with a finger and then 12v bridge coil to operate?

Paul_13 · February 10, 2019, 05:34:19 PM

I've charged up the vac tank and put 12v on solenoid and works perfectly. Got to do ssv next

Sent from my SM-G965F using Tapatalk

Paul_13 · February 10, 2019, 05:39:29 PM

Ssv takes a lot more vacuum to move. But it moves

Sent from my SM-G965F using Tapatalk