OEM Engine & Auxiliary parts (Big lot available)

[jeff_fohlen90]

I have a comprehensive list of OEM items that I am happy to let go of and below is a list of parts I have available (some sold as a whole system and prefer not to split) should anyone want them. The price I put down will assume that it will be posted (UK only) but message me if you wish to come collect and I will reflect price to you accordingly. I am based in Swansea (SA1) should people from South Wales / South West want to travel over to collect. Pictures displayed below the parts list in chronological order.

1. Stock front undertray - Damage to the passenger side rear tab, otherwise both sides in tact and in good condition. £70
2. Air Conditioning parts consisting of Condenser core, associated pipework, compressor pump, and canister. £90 (Whole system)
3. Stock coil packs with coil wiring loom and Magnecor 8mm HT leads plugged in. £90 (Whole system)
4. Pre 99 spec Y pipe with silicone coupler and clip. £10
5. Air pump and emissions piping for a Catalytic converter consisting of air pump compressor, air pump solenoid and hard pipes for the LIM and the air    valve piping that extends to the Cat unit. £60 (Whole system)
6. Stock Pre 99 spec air intake / intercooler shroud. £20
7. Stock intercooler core and duct with stock intercooler pipes supplied. £50 (Whole System)
8. Stock radiator strut bar that mounts stock radiator into position. £50
9.  Stock igniter assist. £20
10. Stock blow off valve. £10
11. Down pipe and manifold to stock twins gaskets. £20
12. Aluminium WGT AST with mounting bracket. £40
13. Stock oil sump. £30
14. Stock engine mounts sold as a pair. Both steel mounts. £70
15. Eccentric shaft used for 37,000 miles. £70
16. Stock exhaust manifold. £30
17. CNC bored stock throttle body to 53mm secondaries and 48mm primary. New brass butterfly plates supplied. TPS included. £240
18. Stock twin pack, supplied with two new gaskets for either the compressor to Y pipe or to intake elbows. £120
19. Stock 10mm engine studs full set of 16. £40
20. Radiator and AST hose as a pair. £10
21. OEM gear knob (wear on the gear gaiter signs). £30

Corresponding pictures to parts list:

[boosted]

Provisional on front undertray...ill start a seperate thread...my car did not come with 1...runs fine 81degc...ill start a do i nred 1 thread on my build thread for the answer...

Sent from my SM-N950F using Tapatalk

[jeff_fohlen90]

Ok thanks, if you want it maybe we could meet half way to pass it over to you? Let me know if you want it.

[jeff_fohlen90]

Update - Metal AST and Air Conditioning system sold thus far.

[boosted]

Hi Jeff, goona pass on under tray had a look under today and got at least 2 snapped studs to deal with..ill leave as is...

Sent from my SM-N950F using Tapatalk

[jeff_fohlen90]

All good, an update on parts availability as follows below for your interest -

1.Stock coil packs with coil wiring loom and Magnecor 8mm HT leads plugged in. £90 (Whole system)
2. Stock front undertray - Damage to the passenger side rear tab, otherwise both sides in tact and in good condition. £70
3. Stock igniter assist. £20
4. Stock oil sump. £30
5. Stock engine mounts sold as a pair. Both steel mounts. £70
6. Eccentric shaft used for 37,000 miles. £70
7. CNC bored stock throttle body to 53mm secondaries and 48mm primary. New brass butterfly plates supplied. TPS included. £240
8. Stock 10mm engine studs full set of 16. £40
9. OEM Gear knob. £30

Any queries regarding the above, feel free to message. Thanks guys!

[jeff_fohlen90]

Last few items remaining which need going by close of this week due to impending move and prices to reflect last sale -

1.Stock coil packs with coil wiring loom and Magnecor 8mm HT leads plugged in. £60
2. Stock engine mounts sold as a pair. Both steel mounts. £70
3. Eccentric shaft used for 37,000 miles. £60
4. CNC bored stock throttle body to 53mm secondaries and 48mm primary. New brass butterfly plates supplied. TPS included. £150

If they don't sell I will have to store them up permanently so if anyone needs any of the above, please give me a shout and I can get them posted to you promptly. 

[Rotormotor]

Hi, do you still have the secondary split air pipe with check valve that connects to the Cat?
If so how much delivered to BN273DW?
Thanks
Chris

[Grant Monkhouse]

Last few items remaining which need going by close of this week due to impending move and prices to reflect last sale -

1.Stock coil packs with coil wiring loom and Magnecor 8mm HT leads plugged in. £60
2. Stock engine mounts sold as a pair. Both steel mounts. £70
3. Eccentric shaft used for 37,000 miles. £60
4. CNC bored stock throttle body to 53mm secondaries and 48mm primary. New brass butterfly plates supplied. TPS included. £150

If they don't sell I will have to store them up permanently so if anyone needs any of the above, please give me a shout and I can get them posted to you promptly. 

Throttle body still available?

Sent from my VOG-L09 using Tapatalk