BOOSTED FD BUILD.

Dax · September 19, 2016, 02:40:46 PM

This is very sad news!

Sent from my SM-G900F using Tapatalk

boosted · September 19, 2016, 03:06:14 PM

Take it on chin and move on...running 2 high powered rotarys was a big ask...ive never been so skint lol. Ive seen a race car all ready to go that has got my juices flowing....

Sent from my SM-N910F using Tapatalk

C J R · September 19, 2016, 08:02:49 PM

Sorry your selling Jon, but happy you have another vehicle in sight.

Good luck fella.

boosted · September 19, 2016, 08:04:51 PM

Cheers mate...fingers x time.

Sent from my SM-N910F using Tapatalk

clive · September 19, 2016, 09:25:37 PM

Dare I ask, you have seen a race car for sale ?

boosted · September 20, 2016, 03:11:52 PM

Ive seen summit but my heads all over the place...

Sent from my SM-N910F using Tapatalk

boosted · September 30, 2016, 04:29:33 PM

got my fd comp tested By Tim today at Rx motors..

bit low....

front 70 72 71 psi
rear 85 80 83 psi

both at 227 rpm....start instantly hot n cold mind....

boosted · September 30, 2016, 05:54:27 PM

Well im keeping it.....

horaahh! i cant sell it with low numbers but i know it starts and drives great so im keeping...

re japi · October 02, 2016, 07:04:45 AM

Weird, isnt rear rotors that usually has low compression...? But you can save it still. Anyhow, next step is to bridgeport it

boosted · October 02, 2016, 11:09:36 AM

results are disappointing to say the least, but a little higher when normalised to 250 rpm, thing is its starts better hot than cold, about 2 secs it catches hot.

Bobfish · October 03, 2016, 07:58:47 PM

sounds like you've bought a lemon mate, I'll take it off you save you the hassle, 5 grand

boosted · October 03, 2016, 08:01:27 PM

Lol...nah i reckon it carbon build up....needs a trackday to cure it..5 bar front chamber compression....eek!

Sent from my SM-N910F using Tapatalk

re japi · October 10, 2016, 11:07:54 AM

Yesterday bro and I bolted gearbox back to engine and moved it back to engine bay. Also started put all the hoses and stuff into it.

Then we got confused. We couldnt figure out where that hose from engines back plate goes??? You know, that thing under thermostat...

Little teaser for you Jon

LÃ¤hetetty minun E2303 laitteesta Tapatalkilla

re japi · October 10, 2016, 11:29:06 AM

Sorry, brainfart again. I mean that oil pressure thing

LÃ¤hetetty minun E2303 laitteesta Tapatalkilla

boosted · October 10, 2016, 11:30:59 AM

Lol ive just got up from nights...early ! Youve confused me....where and what hose on engine?

Sent from my SM-N910F using Tapatalk

BOOSTED FD BUILD.

Bobfish