high revs/not right

Started by shaf, August 08, 2004, 08:54:01 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

shaf

hi
 wen i start the car the revs shoot up to 2000 and eventually cum down and idels up and down to 15/17oo revs wat could be possibly be wrong wat can cause the high revs also wen these cars go hot do u mean really hot cus u cant touch noting under the bonnet in mine its a 3rd gen t/t any suggestions

antnicuk

both sound about right to me. You can adjust the cold start, mine is turned of as i dont find it needs it
400 BHP - 650 KG\'s = 616 BHP Per Ton of Rotary Power

That\'s the way to do it! :Thumbsup!


Freddy

ooh ooh... I know what this is.. just dont know what its called.. DOH! :confused:

its something to do with lower inlet manifold gasket which is letting air in. Consequently, you\'re revving higher.

But i\'m sure, one of the Guru\'s will answer your question.

shaf

where is the cold start mech and how can i do that or do ihav to show it to a macanic also is it ok to drive the car

antnicuk

Sorry shaf, i didnt read your thread properly.... but,  the waxstat which reads water temp and reduces the idle accordlingy gets stuck with age and doesnt release all the way.  If you stand on the passenger side of the engine bay, on the right hand side of the throttle body where your throttle cable attaches is a small screw with a sping over it. If you tighten that screw you will see it pushes the arm further away from the stop, the more you screw it in the less choke you have.  Worth a try.  I had a leaky gasget on mine when i first go it,  idled fine was low but just a bit lumpy, you will know cos you woill get a massive waft of petrol fumes when you get on boost.  It could ne a vacume line aswell.
400 BHP - 650 KG\'s = 616 BHP Per Ton of Rotary Power

That\'s the way to do it! :Thumbsup!


shaf

cheers m8s antnicuk ,freddy will try it out  in the morning

olly

if it\'s just idleing high when you start the car, then it is completley normal ( eccelerated warmup system). If you start the car with the clutch down and in gear it won\'t do it.

cheers

gsb876

Shaf,

is that your car in the avatar???

If so well done i was after that car a while back but wanted more power otherwise a cracking car mate. From Ben i guess??

Gurj
"Every generation has the chance to change the world"

Mills & Bains guest author :Giggle