Mazda Montrose 13B Turbo bridge port

[Will66]

Brett getting the Ladeez with the Old Skool.

[SSScoupe]

New bits and bobs purchased - here\'s one of the ebaytastic guages:


Also got a shiney K&N oil filter, magnetic sump plug and new oil pressure/water temp/volt guages

Think i may have just ordered the same ebaytastic rev counter!  Cheapest tacho with a shift light i could find with 11k rpm

[Brett]

It works really well - it\'s a tiny bit slow, so I\'ve set the shift light 500rpm lower than it needs to be

[samoht]

Saw this at Super 7 today, the noise is awesome (in a good way).

Very cool, and out of the ordinary (never seen anything like it before).

[Brett]

Thanks Tom
It was a bit of a wild ride over in the rain - but a good laugh! :Giggle

Your FD looks very tidy - definitely a keeper!

[SSScoupe]

It works really well - it\'s a tiny bit slow, so I\'ve set the shift light 500rpm lower than it needs to be

Brett, did you have to do anything different when wiring this up? I ask as it only has settings for 4/6/8 cylinder vehicles...

[Brett]

I used 4cyl setting and the tacho output from.the Apexi power Fc

[SSScoupe]

cool i ll do the same... (not the apexi fc - i\'m not that flash lol!)

[Brett]

Let me know how you get on

[Brett]

So... started to get a drive train vibration... (apparently - not driven it for awhile, but my dad took it for a spin at the weekend)...gets worse with speed.  Not had a chance to get underneath it yet and see whats occurred, but I reckon it could be:

Bolts come loose/out on the center bearing mount?
Flange bolts loose/missing on the UJ\'s?
Weld letting go on the prop adapter?

Thoughts?

[Grant Monkhouse]

Sounds bearing. Can you tell where it\'s coming from?

[Grant Monkhouse]

Does it go away if you push the clutch in when moving?

[Brett]

Not even tried it yet - I\'m basing this from a text off my dad.. I\'m hoping it\'s a sheared/lost bolt... (I think it\'s unlikely the center prop bearing has failed - but you never know...)

[Grant Monkhouse]

It could be a loose prop shaft?

[Brett]

Yeah - but if it\'s loose that means its started to sheer its bolts, which would be a bad thing