porting

Started by billybobbooth, July 19, 2012, 09:00:19 PM

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

Print
Go Down Pages 1 2
User actions

Will66

#15
July 22, 2012, 10:44:27 AM
Porting is definitely a job for rebuild time, although you could certainly clean up manifolds and suchlike with them off the engine and may gain small improvements.
RX8 High Power, Cusco Coilovers, Dotz wheels and flames. Shoe Size 12
 
Apparently putting details of your car spec in your signature means the nice folks on exile-rotorsport think you\'re a fool.  I can think of no higher compliment!

"Eat it with a chopstick!"

dthebuk

#16
July 22, 2012, 12:22:56 PM
Quite a few guys over the pond run big power on stock ports and seem to do quite well. Does your engine really need porting?


\'91 FC TII - Drifter... Under construction :D
:burnout

billybobbooth

#17
July 22, 2012, 01:30:34 PM
I\'m doing a fd manifold mod and was going to port all the intakes to the gaskets. It was worth the question while the engine was out.
If I can fit the rebuild kit in then I\'ll do it but if not will have to just wait.
Cool thanks guys once again.
Print
Go Up Pages 1 2
User actions