Clive's 400 BHP Super GT RX-8 Race Car

Started by clive, April 29, 2012, 05:00:49 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

clive

Today we have mostly been destroying trailers :Thumbsup!

Sort of relevant as its all connected with going back racing.


As some of you know getting the race car on and off the trailer was a performance mostly because it was a little too narrow plus I went over a speed bump a little fast and bent the poor thing :3Confused

However I still want it so it fits in the garage :rolleyes:

Solution, cut it up, drive a tractor over the bed and re-engineer the thing to build a slightly wider, stronger trailer :burnout
All the best Clive

Grant Monkhouse

Well Clive it certainly look like a snug fit!!

boosted

Do you have to take the wheels off to get it in said garage?
92 FD rx7 Twins 13.5psi.  EX Track car
EAT SLEEP ROTOR REPEAT.

clive

Quote from: boosted;872204Do you have to take the wheels off to get it in said garage?

Yes it rolls in on its hubs so I can fiddle it past the entrance
All the best Clive

boosted

Quote from: clive;872205Yes it rolls in on its hubs so I can fiddle it past the entrance

Should not pinched in a hurry! :Giggle

As mine is covered with a few broken rear opening clips and parked at the side of the house....it has become somewhat of a local wildlife haven! Have not actually found an animal in there but there is a smell and evidence in there!:eek:
92 FD rx7 Twins 13.5psi.  EX Track car
EAT SLEEP ROTOR REPEAT.

exiled-viking

don\'t forget to weld on the winch clive it will save your bad back  :rollin:rollin

clive

Quote from: exiled-viking;872252don\'t forget to weld on the winch clive it will save your bad back  :rollin:rollin

Don\'t worry we have extended the A frame for a new whizzy winch :D
All the best Clive

clive

Quick update, we now have a trailer that is suitably strengthened (shown upside down) that is now also wider so the car fits easily!

Also tows better with the A frame extended and a bit cut off the back to compensate :D

Made a box to seal off the pumps etc from me that should keep the scrutineers happy and finally finished tidying the engine bay how I want it.

Fuel pressure gauge all installed plus big red oil light, plus tidied a few things up in the engine bay to get it what I now call finished.

Two weeks to Snetterton :Thumbsup!
All the best Clive

Mr Froggy

Looking realy nice glad it\'s all getting sorted now.
And that trailer looks a lot safer now.

clive

Quote from: Mr Froggy;873263Looking realy nice glad it\'s all getting sorted now.
And that trailer looks a lot safer now.

Thanks Wayne, trailers just as you recommended and not saggy any more :Giggle
All the best Clive

C J R

Well done Clive, looking forward to seeing and watching this at Snetterton. :burnout

Chris

rote8

Quote from: C J R;873269Well done Clive, looking forward to seeing and watching this at Snetterton. :burnout Chris

Me too Clive, looking forward to seeing and watching this pass me at Snetterton. :WaveBye
Sadly no longer with us, RIP Ray, 9 Feb 2021

shaunwil

Can\'t wait to see you running round the track this year, should be awesome :D

Shaun
1994 White FD with A-spec GT3574R - 358bhp at the hubs at 0.9bar :3gears-lh
2003 Mondeo 2lt 130ps Diesel Estate Daily :driving

boosted

92 FD rx7 Twins 13.5psi.  EX Track car
EAT SLEEP ROTOR REPEAT.

boosted

quick q...have you still got the oil light lit on the cluster? If you short the level switch out this light will go out.
92 FD rx7 Twins 13.5psi.  EX Track car
EAT SLEEP ROTOR REPEAT.