hurly

[yonner]

douse the hurley rebuild kit come with everythign or is it just all the gaskets and other boring stuff if so wahre can i get a full one that is top quality

[scooby_si]

not that i\'m a spitful bitch or anything http://www.smileycentral.com/?partner=ZSzeb008\' target=\'_blank\'>http://smileys.smileycentral.com/cat/1067.gif\' border=0> but i personally wouldn\'t touch anything hurley based......if they\'re the "The UK\'s Leading Rotary Engine Specialists" then i\'m a small bizarre dog called billabong http://www.smileycentral.com/?partner=ZSzeb008\' target=\'_blank\'>http://smileys.smileycentral.com/cat/16/16_2_22.gif\' border=0>
Si (AKA the constand bitching X customer of http://www.smileycentral.com/?partner=ZSzeb008\' target=\'_blank\'>http://smileys.smileycentral.com/cat/10/10_2_4.gif\' border=0> Hurley & certainly not "bilabong")

[eddy doyle]

Hi,
I have rebuilted (5) RX7 engines with Hurley 3mm/2mm rebuild kits
and i am very happy with there service.

[yonner]

always thot u was a cat m8 but i supose i thot ren and stimpy we a monkey and a pice of toast when i was younger....... im shure many others still do :S

anyway is the hurly rebuild kit the full bunna or is it just gaskets and shite i also heard u guys sya a new rotor housign is 250 from mazda and hurly wants 600 :S

[iaint]

For that money it\'ll just be the gaskets - not new housings (~600 for a pair normally I think), no new seals etc.

Problem is until you get the engine in pieces you don\'t know what needs replacing.  I think the rebuilders usually reccomend replacing housings and seals as a minimum.  Endplates can be skimmed once and reused.

I\'m sure Carl or Pip @ WGT would be prepared to source all the bits required for a rebuild but I don\'t think htey offer kits a s such.

Iain

[yonner]

yeh we are gona replace all the seals gaskets and rotor housings we are hoping to push 400 horses so we want it strong as for the sideplates we have a m8 who works for rolls roice maintaining jet engins he works the nightshift and on his breaks his boss dotn mind him using the machines u shud see some of the stuff this guy has came up with for us he machined a new crank shaft for my dads jag mk2 and made carbon fiber brake pistons for us :S im shure takign a mill of the side plates wont be any harm for him

[20B_boy]

Take a mill off them and you can thru them in the bin

If they need work they should be lapped/ground.

[yonner]

yeh had words with the guy to day he says if the face is scarched we will surface face grind it and he did say a mill was masiv in his buisnes...................but they make jet engins :S

[MillSpeed]

I\'m still laughing at the "ren and stimpy being a monkey and a piece of toast" bit. What the f*ck are they anyway?

[scooby_si]

Dunno but since seeing them do it it\'s been my goal in life to burp the getisburg address...... But despite numerous crates of stella i have yet to come close...
Si (*boik*4 score &.....)