FC: Engine tolerances?

[L18M]

Anyone have the data sheets for what the engine tolerances should be for fc block?
Preferably a mazda tech sheet or similar.

(thanks in advance prof :p im assuming you have it hiding somewhere in your aladins cave of knowledge

[festa]

Hey Liam, have a look at this site should have the info you require.
Cheers

[festa]

Link http://www.rotaryheads.com/PDF/2nd_gen/ still half asleep

[Prof]

(thanks in advance prof :p im assuming you have it hiding somewhere in your aladins cave of knowledge

Festa beat me to it
 
There\'s a lot of measuring - and you\'ll want some good Micrometers or calipers for measuring the eshaft and bearings - tricky to centre a measuring tool for the ID on the bearings..  If you\'re in doubt, a local engineering firm should be able to assist, but you\'ll only need to check and measure the eshaft for tolerance - as you\'ll be replacing all the bearings I guess.

[Brett]

You\'ll need a surface plate anda  magnetically mounted DTI for a lot of it.

Prof that reminds me - I\'ve found some of my scans, I\'ll do you a copy

[B.Martin]

Prof that reminds me - I\'ve found some of my scans, I\'ll do you a copy

Are you pregnant Brett? :Giggle

:rollin

[Prof]

Prof that reminds me - I\'ve found some of my scans, I\'ll do you a copy

Ta Chief :Thumbs-up

[L18M]

Cheers guys, much appreciated will check out the link.

Lmao ben!