new project car

[MONSTER]

Best of luck with this Brian,  I think its fantastic that you are willing to to give it your best shot - rather than just make do.
The result will hopefully be truely amazing:D

Sorry you couldn\'t contact me last night - was it very important?

Best regards

Steve

[bnaellis]

I spend a lot of time asking the seasoned experienced rotary guru\'s questions how to\'s etc so yes experience is something I lack personally but as long as experienced people are willing to share their experiences then it means I shouldn\'t have to travel down the long lonely expensive lurning curve road that they had to to attain to the same goal.

There will be 25 psi 13b\'s running here soon you wanna tell me more ? is it it secret at the mo ?

I\'m really looking forward to this though I must admit just can\'t wait to get stuck. I f money were\'nt an issue it would be ready so much sooner than rotorstock 2005 but you said there are always limiting factors.

Engine build mmmm I\'ll actually have two. Running that kind of boost i\'ll definitely need a spare handy. To be honest of the car was to be more standard as far as power is concerned I would of done it myself but I am not experienced enough with different kinds of race clearances on parts as i will be revving to
9,000-9,500 rpm this is very important. Engine will be built in the U.S I believe not not made up my mind yet.

Main thing will be the looks it will be quite special. If I run out of cash I will have to sacrifice some of the performance goals but as long as the styling is finished that\'s the main thing.

rgds