Anyone good with the loom/wiring diagrams

[DR SCHNITZEL]

The signal wires don\'t, no, but the common feed (the B/W wire) is the one you\'ll have a problem with. I think it supplies at least the idle control solenoid as well, plus the purge solenoid if you\'re still running that. Might even supply double throttle too.
 
edit: re-reading what you wrote above. The smaller circled wires are earthed by the ecu to turn the solenoid on so you don\'t need to worry about 12v running through them. The B/W carries the 12v positive.

yeah Ste id like to cut the thick bw wire but, i know it runs other things. im not running the double throttle or the purge, but i do run the idle control. also the wires i cut are close together in the loom and if they are bridged they will spark and melt something.

hmmm, i only have tomorrow. i best get cracking

[DR SCHNITZEL]

Thinking about it, i might just try and single out the bw wire where i have cut it and make sure its poperly capped for now if thats the juicy wire. should stop any potential problem for now.