What single turbo (s) you guys running?

[turbotoaster]

id say more than that stacy, a guy used a gt4088 which did 479bhp at 1bar and 530 at 1.3bar on a streetport in the uk.

since your running a bigger compressor wheel and 1.35bar id take a guess at 550bhp, if your running a big streetport.

on 2bar of boost that turbo will flow 80lb of air, so that about 630bhp for a rotary.

there is a guy on fduk running 1.6bar on that turbo and he says his is running over 570bhp so it sounds about right.

be interesting to see what jono comes up with if its close to them figures

[Jono FD3]

if the 80lb of air is correct, you could get up to 615, but more likely to be about the 520 mark

[turbotoaster]

when you say control 13b stacy, is that mean its unable to be internally modified, also is it an fd or fc engine?

[HaywardRotary]

Jono,

What do your maths say a GT4094 would deliver at 20psi on a control 13B? My figures say a potential 400bhp, with 28psi (ouch) required for 500bhp - do you concur...?

Trying to work out the effects of bridge/street/pp on that - not there yet but sure the fog can be lifted (at least for assumed template specs).

S.

mmmmmmmmmmmmmmmmmmmm:2Rolleyes