White Dials Wiring Diagram or Advice

Started by C J R, February 17, 2010, 01:05:57 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

C J R

February 17, 2010, 01:05:57 PM
Can anyone offer advice relating to wiring a white dial kit in to the FD3 wiring harness ?
 
Thanks
Chris

Prof

#1
February 17, 2010, 01:12:52 PM
Are these the white dial faces that go over the existing gauges - the indiglo type ?
"Plus this engine is probably one of the most volumetric engines going! It passes more air than a herd of cows eating vindaloo\'s" - courtesy of AtomicRex

C J R

#2
February 17, 2010, 01:16:37 PM
Yes.
 
Not sure of the brand, but I guess the wiring will be similar.
 
Any advice will be welcomed.
 
Thanks
Chris

Prof

#3
February 17, 2010, 01:21:02 PM
I wired the power for the black box (inverter thingy) to the contact pads from one of the illumination bulbs that I took out as a result of fitting them - just soldered the wires onto the copper contact pads.
 
The advantage is that they only come on when the dash lights up - which is kind of what you want.  Dimmer function seems to work as well ;)
 
I did find there was \'miles\' too much wire on the dials - so you may want to get some of those fold over cable retainer clips that can be screw mounted - just to keep the back tidy.
"Plus this engine is probably one of the most volumetric engines going! It passes more air than a herd of cows eating vindaloo\'s" - courtesy of AtomicRex

C J R

#4
February 18, 2010, 07:52:11 AM
Thanks for the advice Prof.
 
I can identify a thin black wire screwed to the back of the instrument cluster that must go to earth.

Also attached to the back of the instrument cluster is a small black box (obviously part of the white dial assembly) thats been attached to the back of the insrument cluster using one of the factory screws. One black [earth] one red, at the side of the screw is stated "IGN" which I assume means ignition, therefore providing a live feed to the black box when the ignition is on.
From the output side of the black box there are two wires, one yellow and one green. Where do these go ?

Also the bundle of black wires from the white dials has a number of black twin wires culmunating in a twin thin black wire to connect to the RX7 wiring. What colour wire should this connect to in the cars loom ?

Chris

trotter

#5
February 18, 2010, 09:13:50 AM
\'94 Wiring diagram if you don\'t already have it matey may be of some use.

http://www.ebooksquad.com/2008/01/19/1994-mazda-rx-7-full-color-wiring-diagram.html

HTH

graeme
Work hard, play hard house :D

C J R

#6
February 18, 2010, 12:21:24 PM
Quote from: trotter;673279\'94 Wiring diagram if you don\'t already have it matey may be of some use.
 
http://www.ebooksquad.com/2008/01/19/1994-mazda-rx-7-full-color-wiring-diagram.html
 
HTH
 
graeme

Thanks
Graeme.
 
Chris
Print
Go Up Pages1
User actions