Injector setup ok?

Started by m1tch, December 28, 2009, 10:47:33 PM

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

Print
Go Down Pages1
User actions

m1tch

December 28, 2009, 10:47:33 PM
Hi all, quick question,

FC3S, 13B, T88, extended streetports, 550 primary, 1680 secondary

Enough fueling?

Ed_RX7

#1
December 28, 2009, 11:59:09 PM
yes....get an frp and a good fuel pump also......but i assume you already have these!!!
Edrx7Parts

07531 669 768

"ALL I HAVE IN THIS WORLD ARE MY BALL'S AND MY WORD......AND I DON'T BREAK \'EM FOR NOBODY"

Official Distributor for TURBONETICS, ROTARYWORKS, ATS/CARBONETICS, SHINE AUTO PROJECTS and XFORCE.
Supplier of HALTECH Ecu\'s and components
Also of

Prof

#2
December 29, 2009, 12:05:12 AM
Have you got a compressor map for the T88 ?
 
Have you a horsepower goal in mind - it\'s worth having a target so that you can build everything toward that goal.
 
Those injectors should take you to well over 500 at the flywheel, you could go for 800cc primaries for a bit more without sacrificing too much driveability at low revs/idle.
"Plus this engine is probably one of the most volumetric engines going! It passes more air than a herd of cows eating vindaloo\'s" - courtesy of AtomicRex

L18M

#3
December 29, 2009, 12:14:02 AM
worth adding a swirl pot?
2 doritos on a stick woohoo :rollin

m1tch

#4
December 29, 2009, 07:45:31 AM
Quote from: Ed_RX7;661937yes....get an frp and a good fuel pump also......but i assume you already have these!!!

I have a good fuel pump and will be converting the fuel system to a parallel setup :) with aeroquip fittings :)

AN -10 fuel fittings anyone? :rollin
Print
Go Up Pages1
User actions