Cold Start problem?

[grinder]

ah right

only reason i ask about the clutch

1) when you press the clutch the car starts and run

2) when you leave the clutch out and start it - it does a warm up sequence - which runs the engine at about 2.5 - 3K for about 10 seconds just to get it warm

glad you found the source of the problem though

so the car is going back to pips then for the exhaust - can any exhaust place not do it ??

[Sean]

I\'ve tried all the local garages, they get it on the ramp and see how awkward it is and say sorry, you\'ll have to take it to Mazda. But when you take it to mazda their "engineers" say " whats that?":reallymad

[grinder]

ha ha ha sounds about right to be honest

and i suppose pip is very local for you

[Sean]

My best time so far is 3minutes and 42 seconds lol:rollin

[grinder]

thats impressive

i wonder why all your thread turn into between 5 - 10 pages

[Sean]

What are you trying to say?

[grinder]

ammusing matey - very ammusing

youve been taking lessons of scooby_si

[Sean]

Right!

Cold start is now purfect!:D

Took roof apart to look at the light phenomon! WTF!:reallymad

I\'m getting one 12V signal and one dead signal regardless of ignition, I take this to be normal.

If you open the door (second signal should change to 12V also at this point) everything dies :reallymad What the Hell!!!!!!

[grinder]

your keen on matey - you really are !!

i take it you have checked all the fuses down in the drivers footwell ?

[Sean]

eye!:wiggle Next?

[grinder]

bad earth on the door switches ?

[Sean]

That\'ll be first job tomoz

I\'m off to shop and sleep till tonite

Nite nite

@@[smiley: Sleeping: [7/7_11_5]]

[grinder]

take care matey

[scooby_si]

(shh while he\'s sleeping apparently he\'s too tight to afford my tuition fee!!!! http://www.smileycentral.com/?partner=ZSzeb008\' target=\'_blank\'>http://smileys.smileycentral.com/cat/3/3_3_101.gif\' border=0> lol)
Si

[scooby_si]

seriously thou good luck with your mission.......