My Next Little Job

[Gman]

I dont have a lot of air going to my induction kit, it is surrounded by a high sided tray so i think a direct route for the air is needed.

I have cut two lengths of dyson hose and will run a direct feed from the top of the intercooler to the induction kit.  Nothing like a bit of DIY!!

[richrx]

you silly silly person. Max Power stickers would have done that without any effort.


only joking, have you tried it yet?

rik

[Gman]

Its my job for the weekend! I tried fastcar stickers to take me up to 600 bhp but they didnt work so i think i will stick to bits of old vac cleaners!!!:rollin :rollin

[evildave]

Originally posted by Gman
I dont have a lot of air going to my induction kit, it is surrounded by a high sided tray so i think a direct route for the air is needed.

The tray is probably to shield any hot air from your rad upping your air intake temp. I need to get something similar for mine, on the rollers my air intake temp was 35deg- so looks like i\'ll be dismantling the hoover as well this weekend

[davefrith]

do you guys have front mounts, cos I can\'t see any way of getting piping to my induction kit with the radiator where it is ?

[evildave]

i should be able to get some duct over the top of the rad, through the front bumper cavity, not sure if a standard bumper has room though, i\'ll try and post some pics after the weekend.

[Gman]

I have plenty of vents in my bumper so i should be ok.