Water Temp Sensor - Displaying ---- on Commander??

Started by DMDRIFTING, July 02, 2009, 06:59:53 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages 1 2
User actions

DMDRIFTING

#15
July 12, 2009, 08:00:50 PM
Right, checked and double checked, its getting 5v to the clip and at the clip, the clip could not be rammed on any further aaaaaaaaargh

Its warming up to around 70 degrees cent now, and then losing the signal/display!

DMDRIFTING

#16
July 12, 2009, 08:08:06 PM
Quote from: nikp;622658Sure you\'re taking the wire to the correct temp sensor? The coolant temp sensor is the one under the oil filter.

Just noticed you\'ve said the coolant temp sensor is under the oil filter???


Where?

DMDRIFTING

#17
July 12, 2009, 10:41:50 PM
Have checked for continuity to the 4 grounds on the ecu 3 of them are good, and the pin out \'4d\' has bad continuity.

It is a brown wire does anybody know where this runs too?


Many thanks

DMDRIFTING

#18
July 30, 2009, 05:45:15 PM
New loom fitted by Tim @ RXMotors and Brand new water temp sensor and all is now fine wahoo 250 miles till mapping i cannot wait, roll on the Nurburgring
Print
Go Up Pages 1 2
User actions