2 piece e shaft

[hairyhoover]

+3 bigger pics of the plates please

[HaywardRotary]

cheers karl i will do. i\'ll get some pics up of the build when every thing arrives and i finally start to assemble it.

yeah i want over 10k rpm, but im not happy about the size of my port as i think its a small for what i want so i think i\'ll be sending it back to carl in the next few months to get it made bigger. ive been advised my best port of call for what i want is actually ceramic apex seals so it looks like i will go down that route now.

no im not tubbing it, although i do have lots of chassis mods planned i\'m not going that far in the chassis side of things.

We can certainly do the work you require now that your plans have changed for this.:mmmm
Regards
Carl

[rx jamie]

thanks carl. i was actually going to email you later today to get some quotes  :driving

[BlitzBoy]

Carl when is one of your high powered cars coming to the drag strip? I need some competition lol

[vest_racing]

2 pieice e shaft is naice..:Giggle


Why don`t u just buy a center plate at Green Brothers, and let them do the machine work on it..:yes

[rx jamie]

nah then id have to have it ported from scratch again, its easier just get mr hayward to do it again. plus it would put my postage and tax up when it arrives.