Main table of 1/4 mile times and mph\'s for European rotors!

[Timrxmotors]

Do you want some air suspension? - The Purple Peril might have to inherit  some air bags... maybe we could take them out of the RX8 dash?

[DRAGON]

I thought it was being broken for parts - have you changed your mind?  Or do you have something else lined up? (Either is good news for the rotary community )

No the car is still being broken for parts, put we may keep the shell etc. I will put a thread up soon with the new plans.

[BlitzBoy]

What times are you getting at pod compared to TOTB. Any changes to the engine between running at both venues?

Same engine/turbo config when I ran it again in August late 11s before I mashed the diff, of course since then I have changed the engine and turbo and have run late 11s again on lower boost in October

[Erdin]

Well done Tim good work, and well done to the driver:)

[peterwolds]

gutted ran at elvington today,wanted under 14 best was 14.06 at 105 mph.wheel spin galore on the line,dropped pressure from 32 to 27 at rear no better on bridgestone so3\'s :Grrr

[hotstepper1973]

just got back from pips and very happy with the following figures 421hp at the flywheel and 356hp at the wheels the torque has gone up reasonable to what i think is 368lbft will post up dyno sheet when i take picture of sheet which shows a very smooth power curve.

Hope this is the right place to post up :Talking1

[bobert]

Cane somebody update me on the quarter mile chart?


RX7 FD3s
T-70 Single turbo
Built by me (Robert Wallace)
Street tyres

E.T               11.98
MPH              119
Location        Santa pod
Date             1/7/2007


http://photobucket.com" target="_blank">http://i103.photobucket.com/albums/m141/bobert_wal/img015.jpg" border="0" alt="Photo Sharing and Video Hosting at Photobucket">

[AMH]

Cane somebody update me on the quarter mile chart?

I\'ll get onto it tomorrow.

[mattmaclennan]

Chris Impy

RxMotors FD3S 13BRE/REW mix 1/2 Bridge
HKS T51R

10.91 at 125mph

Santa Pod Aug 5th

Congratulations Chris! Finally all that work paid off! We are all knackered now.

[BlitzBoy]

awesome awesome well done guys now we have two Privateers in the 10\'s Chris and James.

Congrates :god

[DRAGON]

Yes great time, crdit to the driver, but give the guy some power! 125mph is lame. I did 123mph on a T04S at 1.1 bar. You should be getting much higher termainls with a bridge and that turbo. Unless youve converted it to 1 rotor?

[ro284]

Congratulations Chris :Thumbsup! Well done all the guys at RxMotors,
Bob

[Timrxmotors]

Yes great time, crdit to the driver, but give the guy some power! 125mph is lame. I did 123mph on a T04S at 1.1 bar. You should be getting much higher termainls with a bridge and that turbo. Unless youve converted it to 1 rotor?

That is because he was on \'street et\'s\',too much wheel spin! he has done 130mph terminals with the drag tyres.He says he is going to annialate James at Rotorstock,we will see.
I need to go faster in my 1st gen,as Chris has beaten me by 6/100\'s of a second.:mad:

[20B_boy]

Meh, 10s are soooo 2004/5!

[BlitzBoy]

That is because he was on \'street et\'s\',too much wheel spin! he has done 130mph terminals with the drag tyres.He says he is going to annialate James at Rotorstock,we will see.

woohoo those are fighting words, so currently Chris is on a 10.9 and James on a 10.7, only .2 of a second it. This is going to be a cracking showdown