Rear diffuser install RE Amemiya

[Jim_rx7]

It\'ll be tomorrow guys.

I actually don\'t know how it\'s fitted myself as I didn\'t fit it.

[skim41]

Was searching for some nuts and bolts, and found that you might be able to use blind/ spread nuts. However could not find ones that were suitable for square 10mm only up to 8 mm.

[skim41]

if you have rear spats you have the right inserts you can use. I dont have them. ANybody have some part numbers on the rear spats and especially the inserts?

[Jim_rx7]

Sorry for the delay on pics. I\'m working 12 hour days and the weather is so bad outside!

[skim41]

ah you pussy

[skim41]

just finished the install. I happened to have two spreadnuts in nylon which fitted perfectly. HOwever the other side still needed to be done. What you can do is use the rubber grommets, pull them out, make a tiny hole in them, and put a screw threw them upside down, the rubber will prevent the screw from turning. It seem pretty well fixed now. Will let you know on how it goes on the road.