Recommended Specialists???

Started by rotary_rogersFC, October 14, 2008, 02:53:31 PM

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

rotary_rogersFC

Hi guys

I live near cambridge and just want to know peoples opinions/experiences with the rotary garages around the country. who is best to go to from here sort of thing. i just want to get the car checked over and get it mapped after a downpipe back exhaust.

cheers

louis

Sy.

Not 100% certain on location of cambridge but im sure newbury is not massive about of distance (1hour drive) .. Hayward Rotary ... :D

johnf

Cambridge to Newbury is 133mls and 2hrs 17mins - so a bit of a trip.

Get nice cuppa when you get there though.

John
I started with nothing and I have most of it left

sadgoth

near (ish) Cambridge - Jimmy\'s who have a good reputation, but I haven\'t used them I always take the car to Tim at RX Motors in Dorset
Mark
89 Black FC3S Turbo II
1/2 Bridge port   Microtech LT10s   TII Conv Aluminium Bonnet & Leather seats   Koni Shocks Pi Springs   De-catted 3" exhaust  
GT4088 turbo   Walbro fuel pump   1000cc injectors   custom V-Mount   Blitz Boost Controller (ok so the boost controller is still to fit)

Loud? Hell yes! :D

BlitzBoy

Quote from: rotary_rogersFC;544744checked over and get it mapped after a downpipe back exhaust.

cheers

louis

Do you have an Apexi ECU or Microtech? if you getting it mapped, take it somewhere where they have a "wideband" to correct the AFRs
Jimmys is nearest to you but im not sure they do mapping of the Apexi/Microtech, best to ring them
"Piston Killa" 3rd Gen\'94 \'Oldone Racing Full Bridge Ported REW 13b engine with SCR seals\'. HKS T51 KAI turbo BBM mapped Motec ECU

JDS/HKS Street Class Championship Runner up 2011
Rotorstock winner 08,09
http://pistonkilla.blogspot.com/
old spec HB T51 470 @ wheels @ 1.2 BAR, 555 @ fly 10.46 @ 130 @ 1.25 Bar
new spec FB T51 482 @ wheels @ 1.15 BAR, 570 @ fly

New Project
"el fénix" RX2 by Mark & Mark