Help!! quicky question...

[interloper393]

KK i need to know if i cn block off the vac hose coming from the plenum in pic 1, pretty sure it can

And can i remove the thing with the vac hose in pic 2, it attachces to the plenum..

And what that in pic 3 lol.. was also under the plenum and attached to a t piece that goes to a little round thing which looks alot like the thing in pic 1 :S

[bobster]

The Vac Line on pic 1 should go to the Fuel Pressure Reg... so Leave It unless you have an aftermarket FPR downstream of the fuel rail.

Pic 2 Looks like the FPR.. on the bacl of the Secondary Fuel rail So leave it unless you have an aftermarket FPR downstream of the fuel rail.

Pic 3 look like you have wone a spare Solenoid from your rats nest.

[interloper393]

k pic one its the left vac pipe, iv gone non-seq but i cant see where it goes :S

pic 3 bit was removed from here...

[bobster]

Did you remove the air bypass thing under the plenum.. the large thing with the pipe that runs to the air filters?

[interloper393]

that the bit that goes to the air pump? acr thingy? yeah thats all gone

[ro284]

Looks very like a Purge Control Solenoid to me, but not 100%
Bob

[interloper393]

how she looks the noo, pretty much just the plenum to go bck on..

[bobster]

If my memory serves me right... you can sack that guy in the last pic. And cap up the open lines.
Do you have an external boost controller? Profec... AVCr.

If you do, you can sack pretty much everything under the plenum.

[interloper393]

pic 3 theres one of these under the plenum to.. thats the purge control aint it?

[interloper393]

yeah iv got a greddy e01 fitted

[bobster]

Looks nice and clean.... your going for it alright.
There was one solenoid that used to go to the plastic catch tank under the inlet elbow. If you\'ve binned that then fair enough. I\'m just going to have a read of your non-seq thread

Any chance you could make up one of the plates you have for the coils ?

[interloper393]

iv kepted the one under the inlet elbow bud, guna cap the hose coming from the plenum as i cant see how thats guna cause me probs..
Just re-attach the frp one to the plenum again n hope for the best :S

[interloper393]

the plate i just cut the existing one bud lol..

[bobster]

That\'s so pikey...lol

[bobster]

One thing I will say about the non-seq.
When mapping mine when ran out of fuel/injector duty very quickly. Opening up the exhaust side will tend to lean out on a standard Fuel system. Before I was running 0.8 bat relatively happily... once I went non-seq Hi-Flow could only muster 0.5 bar in anger without leaning out.