DIY Rebuild..ish....... HELP...

[Teighto]

that link aint working try this one

http://www.atkinsrotary.com/store/customer/home.php

[RobbieRX-7]

There has been some pretty bad feedback with atkins stuff. I would just use stock new mazda parts in the engine. Nobody else in the world has put so much money and research into the engine than mazda. Ray crowe at malloy mazda is the man for stock mazda parts.

[Grizzly]

There has been some pretty bad feedback with atkins stuff. I would just use stock new mazda parts in the engine. Nobody else in the world has put so much money and research into the engine than mazda. Ray crowe at malloy mazda is the man for stock mazda parts.

In what respect? i know Atkins had problems with there Springs (they will tell you that) but they only sell OE springs now, i have a set of there Cryo treated apex\'s in a single turbo running 400+ hp and not had any issues (touch wood)

i have delt with Atkins alot of the years and tbh if you go on Rx7.com forum you can PM Kathy (http://www.rx7club.com/member.php?u=45079) and you will be in safe hands. I admit though some of the people that reply to e-mails at Atkins are noobs, they must reply to allot of mails and they forget to do stuff.

"Ray crowe at malloy mazda is the man for stock mazda parts." i have heard that too, i have not used him but he has a good rep.

[Grizzly]

i have been using these guys for bits recently //www.rhdjapan.com they are realy good, they no FA about the rotary but there Prices and service is really good.