noisy blitz induction

Seven · January 19, 2008, 01:47:26 PM

Quote from: nick englishok i found the restrictor andrew sent a couple of years ago to me and put it into the pipe of the air pump but made no difference so i tried it in the centre pipe off the right hand filter that i think goes under the manifold somewhere and this has solved it hopefully this will make no difference to the running of the car/emissions:Nono!

Hello i was wondering if this help with the mooing soubd
i have recently changed mine and its driving me crazy
did this cause any problems down the line?

nick english · January 19, 2008, 04:41:09 PM

yes it sorted it and no more moooing lol

Seven · January 20, 2008, 02:11:04 AM

thanks for that

would mind explaining how you went about fitting it in

did u not hear the clutch of the air pump through the bung ??

did not mess with cars performance at all??

nick english · January 20, 2008, 09:20:06 AM

Quote from: Seventhanks for that

would mind explaining how you went about fitting it in
did u not hear the clutch of the air pump through the bung ??

did not mess with cars performance at all??

removed the small diameter pipe on the right cone and pushed the bung up the pipe and reconnected it.
you can still hear the clutch working when bonnet open but no noise when driving.
has since been through an mot and passed on the emissions so was fine and no difference at all with performance.

Seven · January 20, 2008, 10:02:34 PM

nice , may i ask what you used for the bung ??
because i have tried many different things but are all a lil big and i tried to cut something round and put it in there but i bent it putting it in ??
and is 13mm correct i thought that size hole would still make a noise

also did u place it near the engine side of the hose or airbox side??

lol... i appriciate any help you can give me

nick english · January 21, 2008, 09:41:53 AM

Quote from: Sevennice , may i ask what you used for the bung ??
because i have tried many different things but are all a lil big and i tried to cut something round and put it in there but i bent it putting it in ??
and is 13mm correct i thought that size hole would still make a noise

also did u place it near the engine side of the hose or airbox side??

lol... i appriciate any help you can give me

mine was made of alluminium approx 15mm in depth with three 2mm holes drilled in it fitted it in on the airbox side.i know someone on here cut the top off of a broom handle and drilled holes in it allternatively you could measure the internal diameter of the pipe and get an engineering firm to make u one.
:cheers