13b EGI in a series 3 1st gen ???

[hawker182]

Few pics in the 2nd gen section if you wanna take a gander.

[shaunwil]

I\'ve ordered my engine off tim in the end. Its a runner thats been rebuilt so hopefully dropping it in within a couple of weeks !

Shaun

[mpk490p]

what did you go for in the end?

Mark

[shaunwil]

The most i know about it is it is a 13b egi that was rebuilt 5yrs ago. I only need the bare block and intake side. Should let me get the engine swapped over and running better in a short space of time.

I\'ll do a write up once i start because iformation is sketchy on ausrotary and its all related to the T2 engine.

Shaun

[grinder]

woohoooo pencil me in for engine removal

[shaunwil]

What about the fitting bit :p

Shaun

[mpk490p]

sounds like your gonna have some fun, plenty of pictures and a good wright up!!:Thumbsup!

Mark

[grinder]

you know me mate - always happy to help ( either removing engines or putting them in )

you will have to let me know when you are "thinking" or starting - the little one is due on the 22 May - so not sure how much time i will have

Stu

[shaunwil]

Don\'t worry bud. Im off the week before and was looking at doing it then. But there is alot of work to do before fitting the engine that may force me to postpone the installation and do my suspension instead !

Hope mums doing very well and all goes to plan

Shaun

[grinder]

im hoping it goes to plan aswell !!

if you need a hand in the evening - just let me know

[shaunwil]

don\'t you worry, I will

Shaun

[grinder]

good man - you have a PM winging its way to you once i write it