Fuel Temp Sensor............

[n4bes]

Where will I locate the fuel tempreture sensor.........

Searched the forum but can\'t find any idea.............

Piccies would be superb...............

Thanks All

[Jit]

its on the secondary fuel rail (the long thin fuel rail)

http://jitesh512.fotopic.net/p33293899.html
http://jitesh512.fotopic.net/p33293898.html

In the first picture, right next to the blue ign lead on the table (on the front of the table above the drawer), theres a green plug right next to the engine mount. Thats the fuel temp sensor there on the secondary fuel rail.
The second pic shows (sort of) where the secondary injector rail is in relation to the primary rail. (the red plug is on the primary rail)

[Fish]

If your running a PFC then you dont need it.

Fish

[n4bes]

its on the secondary fuel rail (the long thin fuel rail)

http://jitesh512.fotopic.net/p33293899.html
http://jitesh512.fotopic.net/p33293898.html

In the first picture, right next to the blue ign lead on the table (on the front of the table above the drawer), theres a green plug right next to the engine mount. Thats the fuel temp sensor there on the secondary fuel rail.
The second pic shows (sort of) where the secondary injector rail is in relation to the primary rail. (the red plug is on the primary rail)

Thanks alot mate, I will look tomorrow..................

[n4bes]

If your running a PFC then you dont need it.

Fish

It was the PFC that made me aware it was faulty as the heat light is on in the dash............??.

[allstaruk]

Isn\'t the heat light being on normally caused by a problem with the heat sensor on the cat, or lack of.

AL

[n4bes]

Isn\'t the heat light being on normally caused by a problem with the heat sensor on the cat, or lack of.

AL

Hi Mate,

It\'s decatted.

When you fit a PFC the light is used as a warning light for any potential issues i.e knock, detonation etc. I done a check and the cmmander has highlighted the fuel temp sensor.

[Fish]

The heat light is used as a knock warning light. Mines not connected (1680cc secondary kit) and dont have any issues.

Fish

[n4bes]

The heat light is used as a knock warning light. Mines not connected (1680cc secondary kit) and dont have any issues.

Fish

Now I\'m totally confused..............lol

My PFC has picked up that this faulty, Do I need it connected....??

I am running single on stock boost 0.6 bar with 850cc primary injectors...

[davehg]

its no hastle to just connect it and cable tie it to the rats nest, that will solve all problems

[efiniste]

If you\'ve cut the wiring (or there\'s a short in it) for this sensor you\'ll get an error light. If you leave the sensor connected but not actually in the fuel rail, no error. I\'ve not actually run it without the sensor plugged in so couldn\'t say whether that gives an error but as it\'s the same as cutting the wires then I\'d guess it would.

[n4bes]

Thanks all,

I will check it out tomoz..................