I need a rebuild kit!!

[alban1973]

yes The engine is out now on the stand,  Oil pump is fine, but the chain has too much slack, (1"1/2)  I have not actually had time to get into the engine, but it does look as if it has been apart before as their are numbers painted on all the bolts behind the flywheel. I think as a matter of course the all the seals and springs thrust bearings and ofcourse correct size spacers to be replaced. I will also require a full gasket set.  This is what i am pricing up at the moment, and anything else will be added to the list as it comes along.  Would not like to speculate as to the condition of the rotors, internals or housings at this point.. But from minimal inspection through the exhaust ports things look to be in order.  maybe it would be worth giving you a call after I have got it completely stripped down.....

[Grizzly]

If you are going to buy one of Bruces Kits his site is //www.rotaryresources.com or East coast Rotary.

Rotary Aviation and Atkins are Third Party so you may find an extra few $ on, Plus you may get a better deal of Bruce if a Group buy was aranged with him??

[Jovic82]

try rx motors aswell, they have everything you need all in stock right away!