anyone with a trust intercooler

[Col]

Could somebody please have a look at thier trust FMIC for me, and tell me how many brackets they have holding the intercooler in place please, I have 6 brackets does this sound about right??

thank you for the help Col

[shaunwil]

I\'ve got 3 brackets holding mine into postion, but i made 2 of them and drilled out another. It all depends on how strong the bracets look. I\'d say 6 is more than enough ! Can you physically move it if you get hold of it ?

oh, 1 welded ontop of the intercooler, and 2 on the bottom going to the chassis rails

Shaun

[Col]

Thats for the relpy that is cool thank you, I am not fitting it dragons will fit the intercooler, i just do not want to go down there if I do not have enough brackets. but they do not look very big to hold something so heavy, but maybe thats just me.

[shaunwil]

The two bottom brackets are 2.5mm glav and 50mm wide. The top bracket was an alloy peice welded to the intercooler. Hope this picture helps :



Shaun

[cjle17]

Shaun,

just out of interest where did you bolt the metal tab on the top of the intercooler to?

[shaunwil]

Can you see the shiney bolt near to the bonnet release. It think there was a hole there already at the front, so i drilled though and bolted it into position. Don\'t take my setup as with the stock intercooler, somebody had lengthened the pipes on the intercooler to lower the whole thing down, yours if stock FMIC will sit higher up in the bulkhead.

Is somebody else fitting it in the car ??

Shaun

[cjle17]

No im in the process of fitting it and manufacturing the brackets and could not for the life of me find a sensible place to bolt that tab on the top of the interooler  :confused:

[Eddie]

Hi Cjle17

I know what you mean by a sensible place for that bracket on top of the intercooler, I finally posistion mine in the place for the bonnet releace catch  (pic attached) seeme dthe only resonable place, unlike Shaun I have not had my intercooler altered, took a little bit of messing around but it fitted.

I think it sits a little high but it was the only posistion I could get which allows the pipes to clear the re possitioned rad.
I have more pics of my setup if you require, I also had to use my own brackets as mine came without any.

Cheers

[Col]

More pictures would be great, did you have to move the radiator back? pictures of the brackets would be really good? How hard is to fit for someone with little experiance??? :cheers

[Eddie]

Hi Col

Well little experience that would  describe me mate, I have never tried anything like this before.
the air con rad and normal rad are now in an almost upright posistion and they dont sit too mear the fmic, plenty of room

The brackets, I was able to re use some of the old brackets which were taken of the cars radiators to reposistion the rads and air con rad.

I will take some pics of the setup and mail them to you.

Cheers

[Col]

Lee that would be great thank you.

[shaunwil]

Make sure you don\'t just bury the powersteering line under the intercooler and stop the flow of air to it. It gets extremely hot and you can kill your pump if its run too hot. I bought a power steering cooler and mounted it behind the intercooler, the fluid only gets mildly warm now ! I got it off ebay aus and it works really well!

Shaun

[Col]

More pictures of the brackets and mounts please fellas, I am thinking of haveing a go myself, God help me!!! :p

[shaunwil]

[shaunwil]

Hope this helps, plus i\'ve mounted the rad on an angle to allow more air to travel through it ! I didn\'t put the air con back in the car, so removed the rad, piping and the pump !

Shaun