Intercooler pipes

[dturpin]

Hi

I am looking for some help, I am fitting a Greddy FMIC to my FD, and I need to get some pipes made for it.
Does any know of anywhere that can supply aluminium tube with a diameter of 70mm, I need a short straight length and some bends.
Any help would be appreciated.

[davegttph1]

bends can be made with samco hose angles.... pretty cheap and straight alloy pipe can be had from pace, they will do a meter for about £7...

[dturpin]

Would like to have as little amount of samcos as possible though, will consider it if nothing else comes up.  I have just e-mailed Pace to see if they can help.
Thanks for the advice.

[shaunwil]

a meter of 70mm is about 14 quid, but the postage is quite expensive. If they cut it into 2 500mm lengths it halves the postage cost.

http://paceproducts.co.uk/php/products_info.php?parent=7&productID=raccess/swagedtubes

The samco setup does help you get up and running. Was happy to go that route just to check that i was happy with the air temp before going over to alloy pipe.

Shaun

[dturpin]

May have to take the samco approach myself.
I am after some bends more than anything as I have got a mate who can weld aluminium.
Or if anyone has got a set of pipes from a greddy fmic they don\'t want, I might have them.

[shaunwil]

Its extremely hard to find pipes. Its hard enough finding somebody to supply the alloy bends ! If your mate can weld alloy it isn\'t a bad idea. Have you worked out how many bends you think you need ?

Shaun

[rx7veilside]

make a template and fusionfabrication.com will make it in polished stainless..he did mine great job and good price