How long can it stand for???

[Mulv]

just a quick one, my turbo is off the car being repaired, and she has been standing for 2 months now.

hoe long can I leave it as i dont want her to seize up at all, I assume i cant turn her over with the turbo and related bits off the car??

thanks Graham

[sdminus]

When I left mine over the winter I gave the main pulley a couple of turns a week to keep the seals the stuff nice and free. I used a 19 mm socket. Be sure to turn it the correct way... Sunday afternoon job on the way back from the pub!!!

Scott

[TRex]

Advise removed, as always there is someone here with a lack of knowledge that feels they know best.

 rgds

[Mulv]

thanks, so if i take the plugs out and turn it over, even with the manifold exhaust and wastegate off it will be ok???

[sdminus]

I didnt remove the plugs. Just turn it over
Scott

[grinder]

any news on the turbo matey ??

[TRex]

Good luck,

[nikp]

I had mine standing for about 3 months - did nothing to it, and it was fine. Didn\'t even turn the engine.

However, you don\'t really need to take the spark plugs out to allow turning the enigne easier, as at that slow speed the apex seals will not seal properly, and no compression of air will be being made - therefore the engine should be easy to turn over - you can grab one of the drive belts and turn it over, it\'s that easy!

[Mulv]

still waitig grinder, they are having probs getting parts

[MillSpeed]

at that slow speed the apex seals will not seal properly, and no compression of air will be being made - therefore the engine should be easy to turn

Ah so that\'s why. I was always a bit concerned by how easily my engine would turn over by hand, but of course there\'s only the strength of the apex seal springs letting you build up any compression. I still need to compression test my engine tho.

[ds2000]

Which way is the correct way? CW or ACW?

[nikp]

I am no expert at this point, but with these engines, i don\'t think it matters.

[MillSpeed]

Well the engine rotation is CW when looking from the front, so it\'d prob be best to rotate it CW, but like nikp says it probably doesn\'t matter.

[Zimmy]

I got mine started - after it had been sitting off road outside for 3-4 Years!
Ok it had been started 2 years ago too. What I was told was remove the EGI fuse to prevent flooding and turn it over a bit to get the oil up and about.

The only thing I had to do was charge the battery put new petrol in it as the stuff in it had went off. The tyres hadn\'t fared well either so its worth turning them every month or two and make sure they don\'t get flat.

 So 2 months should not be a problem!

Changed the oil and its running like a sweetie now.

Z