RX323 Project - Chassis Brackets

[travellinbob]

hey mike, well loads have happened for all of us sounds like since you went below the radar! we are now living in oz, have been here for about 8 months now, building a house etc.... chuck us an e-mail for a proper catch up. float7@hotmail.com
   kinda wish i was still in the uk but as i would love to grab the 323 project of fo you.
   hope it all goes to a good home!  talk soon, michael.

[MikeLMR]

The Wellers on the back are 13x10 with a 4x108 pcd (and a 4x100?) I can\'t recall the offset but I think it is negative, and  they have a pair of brand new soft compound Kumho 235/45/r13 tyres on them. - 150quid for the pair.

the fronts are 13x6.5 (or 7\'s can\'t remember) still in the boxes 50quid for the pair.

I have 3 Kirkey seats, all are brand new and in 3 different widths (need to find out what sizes they are) and two have covers.  Would like 100 each for the ones with covers and 75 for the one without.

Can sort photos at some point but the parts are not local to me at the moment.

[dubber91]

thats cool - because of my more \'rotund\' frame i think i\'ll be needing the wider seats!

The wheels are for a mazda 1000 - im guess the offset is going to be all wrong?

[dubber91]

i like lots of your parts.....is it just easier if i come over? haha

[MikeLMR]

well they all fit nicely inside the shell of the car, if you have the cash you can take the lot! (there are a lot bits that have collected over the years , I need to have sort out and compile a list in fact!)

I don\'t know about the offset but the 10" wide wheels used to stick out the standard 323 arches by about 6" !!! (they are properly wide and have the opposite offset to the standard wheels) IIRC they have 4" of rim on the inside and 6" on the outside. I have the CAD models I did somewhere on my old laptop.

[dubber91]

did you sell the star-style 4x110 wheels then?
if you can get measurements of the kirkeys, that\'d be great.

[MikeLMR]

No they are still there, I think all of them are with the car, a couple of them might be knocking about in various garages though. I will have to check out what is where and get back to you on it.

[jon newman]

hi mike, do you want to sell the 6 port manifold? and front strut tops any e mail address?

cheers jon

[travellinbob]

carefull mike!!!!all this interest in your car might make you want to finish it!??
  michael.

[MikeLMR]

I can\'t remember if I still have a 6 port manifold? I will have to look!  It\'s all a bit grey as to what is boxed up in the garages.

[jon newman]

cool, its a shame we dont have 50 hour days and require no sleep, projects like this would get done in no time atall.

jon73@jnlags.wanadoo.co.uk

if you find any other bits.