Timmys FD3S

[Timmyc]

Another update:

Fitted all the wiring loom

Trial fitted the maaaaassive intercooler and rad setup but looks like I wont be able to use it due to keeping the a/c and twin oil coolers but will be able to when I get bored of the twin turbos and put on the backup to4r and ditch the a/c etc







Built up more of the engine bay, fitted p/s, a/c, abs, brake servo, brakes pipes, clutch master cylinder, braided clutch line etc etc

Cleaned up the fuel tank and fitted an in tank bosch 044

Bolted rollcage into final position using strengthening plates and refitted rear seats and paneling cut to suit

Rear bumper back from paint and fitted

Fitted a carbon rear diffuser and rear exhaust section





Re amemiya light cover back from paint and fitted



Tailgate back and fitted, glass in but ideally need a better condition one and a seal



Got the doors back and lambo hinges to see what they are like but waiting till nearer completion to fit the doors

Made 1 good set of twins out of 2 knackered sets, lined my lim with heat protective material and did the same on the o/s chassis leg and around strut tower and brake servo, went a little higher and further back than needed for the sake of the single turbo later









Used my greddy front mount I had and turned it into an in engine bay intercooler, made alloy brackets to fit it, trial fitted so c west style carbon lights as well





Tonight I have replaced all the fuel line and brake fluid to clutch master cylinder feed, all vaccuum pipes, double checked the wiring and solenoids, need to make some blanking plates for air pump removal gubbins, intercooler pipework, some coolant to throttle body pipes then should bd about ready to try fire her up :-)

[fil_auto]

Coming along very nicely, loving the rear end

[Kitsan]

Really looking forward to seeing this finished TimmyC, are you stripping the inside or keeping it stock? Any thoughts of a cage?

[Timmyc]

Thanks Phil :-) hopefully the whole thing should look pretty cool

All standard inside Kitsan apart from colour coded dash panels, door trim and a cusco dash dodger cage, rear seats refitted with cutouts for cage