rotary compression tester in SW?

Started by L18M, May 28, 2011, 06:31:55 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

L18M

May 28, 2011, 06:31:55 PM
anyone know anybody with a rotary compression tester in SW (somerset area)?
Just want to get a test done as when warm it takes a little longer to start.

Water temps are fine (constant 82 deg C), oil press is fine (on stock gauge) and not burning lots.

cheers
2 doritos on a stick woohoo :rollin

captainbizzaro

#1
May 28, 2011, 06:46:24 PM
What ECU are you running? When you say longer - how much longer? Just wondering as a comparison to mine. Mine starts better from hot than cold though as my cold crank map is quite rich.

davehg

#2
May 28, 2011, 07:16:40 PM
keith on here has one, he is in the trader section
There are performance cars and then there is the RX-7...........

12.3 second 1/4 mile, terminal speed of 122mph (1st ever drag run on a TO4R)

engine built by....... umm me! now powered by a T51 Kai......

davehg

#3
May 28, 2011, 07:17:12 PM
he is down mine possibly tomorrow so could get him to bring his tester and meet there if you contact him
There are performance cars and then there is the RX-7...........

12.3 second 1/4 mile, terminal speed of 122mph (1st ever drag run on a TO4R)

engine built by....... umm me! now powered by a T51 Kai......

L18M

#4
May 28, 2011, 10:07:00 PM
cheers dave, have txt him :)
2 doritos on a stick woohoo :rollin

L18M

#5
May 28, 2011, 10:08:44 PM
Quote from: captainbizzaro;765346What ECU are you running? When you say longer - how much longer? Just wondering as a comparison to mine. Mine starts better from hot than cold though as my cold crank map is quite rich.

AP engineering pfc
on cold it runs after 2nd or 3rd crank.
when warm it usually runs after 5th or 6th crank but seems to struggle a bit.
2 doritos on a stick woohoo :rollin
Print
Go Up Pages1
User actions