Where to source parts for rebuild?

[suba]

Now that my engine has been stripped down I need to start buying bits for the re-build - I need to source this lot with genuine mazda parts (apart from the apex seals):

FC gasket set including water seals
stationary gear bearings
rotor bearings
set of oil control O rings
set of corner seals and springs
set of side seals and springs
set of PTS apex seals (not sure if 2mm or 3mm are the ones to go for?)

I also need a rotor and housing - but I\'ll get those from Tim at RX Motors.

If anyone could advise me of the best places to order that lot I\'d be very grateful.:mmmm

[12at]

Full rebuild kit is best to be purchased from AUS i would say for about $1400 which will give you everything from oil control rings and springs, gaskets, side seals, apex seals and springs, corner seals the works

[BlitzBoy]

Rotaryarts or Dragon  have Mazda rebuild kits normally in stock, Rotaryart are the UK dealers for PTS seals

[suba]

Thanks - I\'m not keen on ordering from abroad as I dont think I\'m going to save anything with import duty and the exchange rate as it is.  i also have a lot of hasstle if any wrong bits are sent etc.:Thumbs-up

[m1tch]

You can\'t run 3mm seals unless your rotors are milled out to 3mm - so im guessing that makes it an easy (and probably cheaper) choice for you

[TRIND-FD]

Cant tim supply the whole lot. Would of thought he could.