How do you remove front/rear bumpers?

[gandyRX]

Question as above really how do you remove the front and rear bumpers from a fd 1993 rx7, only ask because i finally got my c west kit yesterday and need to test fit and trim it before it goes to paint, also are there any major bolts on the front and rear? the kit i got comes with some holes that need to be drilled but i cant see any major bolts for it to fix to,
 
thanks guys :3gears-lh

[SiH]

Front is just a bunch of bolts- pop the headlights up and there\'s a couple in the wings, then undo the ones on top of the slam panel. Then I think there\'s anotehr one either side at the back of the bumper holding it onto the wing (you\'ll need to peel the arch liner for this) - IIRC that\'s about it - the nosecone then comes off and reveals the support bar.

The rear is a bit of a bugger. Pull the trim out of the boot, and there\'s two either size in the inner wing, right at the edges - expect lots of scraped hands! Then whip the rear lights off and you\'ll see a load more over the top.
IIRC it\'s then held on by two clips on the rear wings - you just need to keep wiggling until they pop.

I\'ve got a feeling there were a few more as well, can\'t remember how it fixed to the bumper support?

[ashc]

thats about right, the rear bumper confused me until i looked at the service manual and saw the clips and gave it a good pull! dont forget the bolts in the wings though, i definitely scraped my knuckles and dropped a nut into the wing trying to stick the bumper back on again!

[REVIT93RX7]

The front is pretty simple, raise the lights remove the undertray.  There are some bolts that hold it to the fenders.  If I remember correctly 2 per fender.  The rear is a little more work.  Remove the rear lights, and the inner trunk plastics.  Along the backend of the rear fender wells are some long nuts.  About 1.5 inch long.  2 per side, you need to remove those and then the fun begins.  You need to reach your arm down along where the side marker lights are and depress the 2 inch long plastic clips.  The cover will then pull off once the top clips below the lights have been removed.

[NurburgRob]

If it\'s genuine C-West you won\'t need to test fit, it will be perfect!