PFC fitted + remap = plenty of bhp

[bnaellis]

Originally posted by eatmyrx7dust
That sounds amazing...I have virtually the same set up but already have 1600 injectors fitted and engine ported and running at .9 only get 310 rwbhp. Can you post the print out.
I think I am going to have to go back to WGT and ask for my money back !!

Only your fmic is different...could that make a 100bhp+ differrence ? Mines a bigger SMIC.

Are you sure you have a T04R and not something bigger ??

no he\'s talking flywheel horsepower, your talking rearwheel.

[eatmyrx7dust]

BHP figures are a mystery......some claims seem to be too high for the mods specified.
WGT uses a DynoDynamics setup which attaches to the rear wheel hubs after the wheels have been removed.
Therefore he is only quoting  at the hubs figures.

A rough translation of hubs to flywheel is add 20%. Although he thinks the readings he\'s getting maybe upto 10% down due to unit needing calibration.

The following graph was achieved at two boost settings 0.75 and 0.85.

[Oedipus Rex]

Originally posted by eatmyrx7dust
BHP figures are a mystery......some claims seem to be too high for the mods specified.
WGT uses a DynoDynamics setup which attaches to the rear wheel hubs after the wheels have been removed.
Therefore he is only quoting  at the hubs figures.

A rough translation of hubs to flywheel is add 20%. Although he thinks the readings he\'s getting maybe upto 10% down due to unit needing calibration.

The following graph was achieved at two boost settings 0.75 and 0.85.

my figures come from exactly the same machine as yours mate.

[Icesurf3r]

I had mine mapped by Pip Yesterday. Went from 296.3 at the fly wheel to 332 at the wheels, but again Pip did stress that the machine was between 10% - 15% down on what it should be reading, so realistically i should be looking at 370 RWHP, thats  at 7100 RPM running a T88 @ 0.95 bar.

So i was very pleased until my clutch went on way home My clutch nightmare

Couldn\'t have come at a worse time with rotorstock just around the corner.

But nice to see you getting some good results Babz, looking forward to seeing what u can get out of her when mapped to over 1 bar.

[Dan Norton]

Thats great babz!!!!

Good result dude.......cant wait to get mine done now :wave

[babz_audio]

thank you people

Pip did tell me that his machine was reading abit out...

still need to get the graph scanned

Icesurfer, good results but sorry to hear about the clutch problem