strange bubbling noise

Started by davehg, August 20, 2004, 05:04:50 PM

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

davehg

just wondered if anyone can help,

ive noticed recently after turning the rex off that i can hear bubbling noises comming from the radiator i think?? i allow the car to run on the turbo timer for approx 2 mins but this still happens, is it normal? or is allowing it to run for that long allowing the car to get hot again as its sat still nd not pushing cool air through the rad.

thanks

dave
There are performance cars and then there is the RX-7...........

12.3 second 1/4 mile, terminal speed of 122mph (1st ever drag run on a TO4R)

engine built by....... umm me! now powered by a T51 Kai......

Andyp

have you had a service / replaced your coolant recently matey? I say this as I had this problem when my system wasn\'t bled correctly, it basically means there is air in the system.

It is more than common after a hot day / hard run for the turbos to dump heat into the system but that would causing a swishing noise rather than a bubbling

Sounds as if there air in there, if you have had the coolant replaced you most likely need it bleeding properly
The Beatles were prats.."Money can\'t buy me lovveeee".. utter rubbish. You can buy love here

Buy my car foo! :D

MikeLMR

is it using water or leaking ? could be boiling the coolant if your loosing pressure. Is the rad cap in good condtion ?  (ie. is it releasing the pressure to early)

~ Mike

davehg

it hasnt had the coolant touched for a few months, but after taking off th collant cap the seal liiks slightly perrished in one spot. how do i bleed the system, is it just a case of running it with the cap off and squeezing the pipes untill the air is out? or is there a bleed valve?
There are performance cars and then there is the RX-7...........

12.3 second 1/4 mile, terminal speed of 122mph (1st ever drag run on a TO4R)

engine built by....... umm me! now powered by a T51 Kai......

Andyp

sounds like it\'s what Mike said if the caps screwed

I\'ve only ever seen it being burped a couple of times rather than done it myself

Far as I\'ve seen, take the main water filler cap and ast cap off and put the coolant mix in each of the points slowly with the engine running... spills a bit and gurgles a lot.

Fill it at the points (AST and main water filler cap) until it\'s full.
The Beatles were prats.."Money can\'t buy me lovveeee".. utter rubbish. You can buy love here

Buy my car foo! :D

davehg

i know thwe main point in the centre of the engine bay bt where/ what is the AST?
There are performance cars and then there is the RX-7...........

12.3 second 1/4 mile, terminal speed of 122mph (1st ever drag run on a TO4R)

engine built by....... umm me! now powered by a T51 Kai......

scooby_si

could it also be the air con? I no my scoob used to c/o air con & even my modeo still burbles a bit after shutting off specially if i\'ve been a/c\'ing it....?
Si (possibly full of hot air http://www.smileycentral.com/?partner=ZSzeb008\' target=\'_blank\'>http://smileys.smileycentral.com/cat/7/7_2_100.gif\' border=0> lol)