Fd3s parts galore

Started by rx7ali, August 16, 2015, 10:21:10 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

rx7ali

---No silly offers as Im not rushing to sell anything
---I may have other bits kicking about so just ask
---All prices are collected or plus postage.
---Can't be assed to post anything big but will at a push.
---pictures upon request

SOLD- Sealed block low compression on the rear housing (no sign of housing or rotor damage through the exhaust post but unknown condition £400 for bare block OR £600 including UIM,LIM, Flywheel, blanking plates (used for single conversion and imp removal), alternator, water housing and ast removal neck.

SOLD - Complete engine, known good order as its in bits and was going to be my go to engine for a rebuild. It was a water seal failure and DOES NOT have corroded housing, was likely a pinched band. Either way it's in great nick, housings have minor wear all within mazda limits for a rebuild. £700

Atkins master rebuild kitt minus apex seals and oil filter. £700

Als unbreakable apex seals £300

Other spares including Oem irons, e-shaft, sump, wiring, manifolds, etc, etc just ask.

ACT paddle clutch, sprung type. £350

Coil packs on a diy mounting plate (ac pump location) £25

Spare OEM flywheel £50

Bosch 1680cc injectors, Indy blues with collars. They were cleaned and flow tested around 1000 miles ago. £150

billet bits fuel rail to match above injectors £80

Primary fuel rail with 550's as above cleaned and flow tested around 1000 miles ago. £50

Freddy inlet elbow (fake gready) £50

Dm Motorsport idler pulley £75

Low milage stock gearbox, perfect working order, will include short shifter and dm Motorsport brass shift collar. £200

Apexi PFC, 8 bit to suite 1992 fd. £500

Vmount.. Home made... functional. Including pipe work for £350 Will include the vented bonnet and fans with extended cables for a mere £50 more :-)

Kv85 ht leads £25

Oils sandwich plates £20 each (dm sport and gtrex? One. Dm hips missing the rubber seal.

Joeh

Dropped you an email regarding the vmount and other bits, dibs on them, please send images to joeh@ogsmechanics.com or to my mobile 07944945944

Thanks
Joe

rx7ali


rx7ali

Rebuild kit and ALS seals are now sold


rx7ali


rx7ali


rx7ali

Injectors, rail, throttle and elbow all collected

rx7ali

Clutch reduced to £250 as need of resurface for which I have been quoted £45+postage