Injector blanking plugs?

[Grizzly]

Hi all.

Does anyone know where i can get hold of a pair of Injector Blanking plugs?

Ideally i am after a non permanent way of blocking up the two center injectors on my Atomicrex lower inlet manifold? (similar to a Xcessive lim)  

Any ideas where i could get hold of some thing that would fit the bill?

[davehg]

What about the press fit caps that are used on engine blocks in waterways? You could take them back out easily enough as they are a press fit

[shaunwil]

I had some on the 13b EGI. They where just a turned boss with a groove for an o-ring to seal te hole. A plate held them down in place.

Shaun

[Grizzly]

I have contacted Dm Motorsport who think they can help

I was going to just fill the two holes with Liquid metal but that seems a bit permanent, I don\'t think it would fall out as there is a nice lip on the inside (think its where the Injector pushes up to)

[K1HKS arse]

Extreme rotaries do injector blanks

//www.extremerotaries.com